喷射器 CYR10
Cleaning system for analysis sensors
Includes electrical valves for pumping
water and cleaning agent
Protection class: IP 65
文档/手册/软件
-
Technical Information CYR 10
Spray cleaning system for pH, oxygen,
turbidity and conductivity技术信息(TI) -
Operating Instructions CYR 10
Spray Cleaning System for pH, Oxygen and Turbidity
操作手册（BA） -
pH 測定セレクションガイド
産業プロセスにおける pH 測定
竞争力手册(CP)08/15日语 -
CP00010C pH measurement in industrial processes for US market
Selection and engineering guide for your industry and application
竞争力手册(CP)04/15英语 -
Measurement and control aspect of pH using inductively coupled with
bidirectional Memosens technology in flue gas desulfurization process
White Paper CP971C pH measurement and control in a power utility is an
integral part of process. The scrubber efficiency is highlydependent on
the pH. Numerous opportunities were revealed for saving time, as well as
the cost and materials in power plants. In afossil fuel power plant,
the
chemical energy stored in coal, oil, natural gas, shale oil, oxygen and
air
is converted into thermal, mechanical and finally into electrical
energy. In
other words, water is heated to steam, which spins a steam turbine. The
steam turbine drives an electrical generator.竞争力手册(CP)04/11英语 -
CP01202C pH Sensors:Calibrate, clean, perform a calibration check
or...?
This white paper will address
Knowing when to do a pH sensor calibration versus a calibration
check
How to properly clean a pH sensor
How to perform a pH sensor calibration
A decision tree for step by step guidance竞争力手册(CP)02/12英语 -
Cyanide oxidation with NaOCl in galvanic industry
AHC Benelux optimises thanks to pH+ORP sensor combined
By using the Memosens CPS16D combined pH+ORP sensor in our 2
cyanide oxidation tanks, we control this process accurately. With the
Liquiline CM444 transmitter also the rH value is calculated and in this
way
an optimised process control is realised. The measurements are in use
since May 2013 and since then discharge values of 0,0 mg/l heavy
metals or cyanides to the surface water are obtained.”案例分析(CS)09/13荷兰语 -
Cyanide ontgifting met NaOCl in galvano industrie
AHC Benelux optimaliseert dankzij pH+redox sensor in één
“Door de Memosens CPS16D gecombineerde pH+redox sensor toe te
passen in de Cyanide oxidatietanks sturen wij dit proces nauwkeurig.
Dankzij de Liquiline CM444 transmitter wordt ook de rH-waarde berekend
waardoor een optimale procescontrole bereikt kan worden. De metingen
zijn sinds mei 2013 in gebruik en sindsdien worden er lozingswaarden
van 0,0 mg/l zware metalen of cyaniden op het oppervlaktewater bereikt.”案例分析(CS)09/13荷兰语